1911Forum banner

Wilson slip on mag well ?

1K views 4 replies 5 participants last post by  primersinmyshoe 
#1 ·
Hey Gent's:
I want to put on the under grip exstened Wilson magwell on my new SA 1911-a1 and don't want to go through the S&A MSH mag like I did on my Kimber 1911 9mm. and want to save some clams.
Does anyone have one of them on there .45? How does it hold up, fit, look,ect?
or spend the xtra $60 and get the S&A 1 piece..

GaryK
 
#2 ·
I have one on my Government Springfield loaded and it doesn't look bad at all. It seems to be holding up fine. The only thing that you'll have to do is take a dremmel to the back of your grips and recess them where the part of the magwell loops around the grip screw bushings so you'll get a flush fit. You may also want to look into getting magwell grips as well if y ou go with the magwell.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top